Net-optics iTap 10 GigaBit Port Aggregator Uživatelský manuál stáhnout pdf (Strana 12)

iTap 10 GigaBit Port Aggregator

Unpack and Inspect the iTap Port Aggregator

Unpack the iTap Port Aggregator and check for damaged or missing parts. The

iTap ships with the following:

• iTap 10 GigaBit Port Aggregator

• Two power supplies with cords

• iTap 10 GigaBit Port Aggregator Quick Install Guide (one sheet)

• iTap Software CD

• iTap 10 GigaBit Port Aggregator User Guide (this document, on the iTap Soft-

ware CD)

• Network and monitor cables

• RS232 DB9 cable for use with the CLI

• Extended Warranty if purchased

You may have also ordered rack unit panel for rack mounting the iTap. Carefully

check the packing slip against parts received. If any part is missing or damaged,

contact Net Optics' Customer Service immediately at +1 (408) 737-7777.

(Note: XFP modules are ordered and shipped separately.)

Install XFP Monitor Port Modules

XFP modules are shipped separately. Remove the temporary plugs from the iTap

Port Aggregator monitor slots and insert the XFP modules as shown below, until

they click into place. The photograph on the cover of this Guide shows properly

installed XFPs.

Figure 1: Installing XFPs

www.netoptics.com

Port Aggregator

LINK

TAP

AGG.

Mode

RESET

LASER

CAUTION!

OUT OUTIN IN OUT IN OUT IN

Network Monitor

A B 1 2

10 GigaBit

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Žádné komentáře

Net-optics iTap 10 GigaBit Port Aggregator Uživatelský manuál Strana 12