Net-optics iTap 10 GigaBit Port Aggregator Uživatelský manuál Strana 51
- Strana / 64
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
iTap 10 GigaBit Port Aggregator
47
The following table describes each available conguration option.
Field Name Description
IP Address IP address of the iTap. The default IP address is 192.168.1.2.
Change the IP address by typing a new IP address in the
text box. This is the address for Web Manager and System
Manager to communicate with the device.
Net Mask Displays current Net Mask of the iTap device. The default
Net Mask is 255.0.0.0. Change the IP address by typing a
new Net Mask in the text box.
Manager IP Address IP Address of the system management computer running
over a WAN. SNMP traps go to this address. Change the IP
address by typing a new IP address in the text box.
Gateway IP Address Displays current IP Address of the current WAN Gateway.
Change the Gateway by typing a new IP address in the text
box.
Port 1 Enable Select ON to enable the laser for Monitor Port 1.
Port 2 Enable Select ON to enable the laser for Monitor Port 2.
Port A Utilization
Threshold (%)
Enter the utilization level that will trigger a threshold alarm
for Port A.
Port B Utilization
Threshold (%)
Enter the utilization level that will trigger a threshold alarm
for Port B.
Port 1 Utilization
Threshold (%)
Enter the utilization level that will trigger a threshold alarm
for Port 1.
Port 2 Utilization
Threshold (%)
Enter the utilization level that will trigger a threshold alarm
for Port 2.
Reset Port A Peak
Rate
Select Yes to reset the Peak data for Port A.
Reset Port B Peak
Rate
Select Yes to reset the Peak data for Port B.
Reset Port 1 Peak
Rate
Select Yes to reset the Peak data for Port 1.
Reset Port 2 Peak
Rate
Select Yes to reset the Peak data for Port 2.
Reset Port A
Statistics
Select Yes to zero all counters for Port A.
Reset Port B
Statistics
Select Yes to zero all counters for Port B.
- User Guide 1
- Contents 3
- Chapter 1 5
- Introduction 5
- Regeneration 7
- Chapter 2 11
- Figure 1: Installing XFPs 12
- Figure 2: Connecting Power 13
- Connect the CLI Interface 14
- Figure 4: CLI login prompt 15
- Network Monitor 21
- To network switch or hub 22
- To monitoring device 2 24
- To monitoring device 1 24
- Check the Installation 25
- Chapter 3 27
- Front Panel 27
- Utilization Alarm LEDs 29
- Link LEDs 29
- Mode LEDs 29
- Power LEDs 29
- Reset Button 29
- Chapter 4 31
- Using Web Manager 31
- View System Status 33
- View iTap Trafc Statistics 34
- Chapter 5 39
- Using System Manager 39
- Install System Manager 40
- Explore System Manager 41
- Create a System Manager Group 43
- Delete a System Manager Group 44
- Appendix A 53
- Specications and Models 53
- Models and Part Numbers 55
- Appendix B 57
- Command Line Interface 57
(14 stránky)
Komentáře k této Příručce