Net-optics iTap 10 GigaBit Port Aggregator Uživatelský manuál Strana 35

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 64
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 34
iTap 10 GigaBit Port Aggregator
31
Change iTap Port Aggregator System Conguration
Web Manager has both read‑only and writable elds. Use the writable elds in
the Aggregator System Conguration section to set conguration parameters. To
change a parameter, type the new value into the eld or select it from the list, and
then click Submit Changes at the bottom of the page to send the changes to the
iTap Port Aggregator device.
Note: ____________________________________________________________________
If you receive a message saying that your browser needs to resend the information
when you try to refresh your browser, return to the main Web Browser page by
re-entering the iTap Port Aggregator IP address in the browser's address bar.
Otherwise, you may not see current data when you refresh the browser. This
condition occurs only if you are looking at the "index.zhtml" page (for instance,
http://192.168.1.2/index.zhtml) that comes up after you Submit Changes.
__________________________________________________________________________
Figure 15: iTap Conguration (bottom part of Web Manager page)
Zobrazit stránku 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 63 64

Komentáře k této Příručce

Žádné komentáře